Bottle Case

PET is a type of plastic used for making bottles for different drinks. After using a bottle is necessary to recycle or converted. An excellent example of conversion of plastic bottle designed by the Austrian designer Zitta Schnitt: from the bottom of plastic bottles produced a purse!

Plastic (PET) bottles (for making purses requires two plastic bottles. Showed Fri pouch is made from the bottom of two bottles of capacity 1.5 l. The remaining Dispose of plastic bottle recycling.)
-Zippy
-Needle and thread
-scissors
-sharp knife
-A template for drilling holes
-Scotch tape

On the bottle is necessary to drill holes to facilitate sewing zipper (smi ka, "zipper"). The holes should be drilled at equal intervals in the same plane, which can easily be done using a template (pattern).

A simple template can be found at the end of this project. Download the template, print it, cut a strip of the template and carefully stick the tape on the bottle.Pa~ljivo promotrite dno boce. Iznad „krune“ uo it ete tanku crtu nastalu u procesu proizvodnje boce. Ta je crta idealna vodilja za postavljanje predloaka za buaenje rupica. Rub predloaka polo~ite uz spomenutu crtu, omotajte ga oko boce i pri vrstite ga selotejpom.

Debljom iglom za aivanje na plasti noj boci izbuaite rupice za konac. Rupice buaite na razmaku od 5 mm.

Thicker needle stitching drill holes through the template attached. At the same drill holes on another bottle.

First bottle carefully with a sharp knife make a cut right to the edge of the template.

Through an opening made insert scissors and cut the bottom of the bottle.

Prepared for the parts bag.

For sewing zipper prepare solid thread, because I had just an ordinary thread, I have used four or end.