Boat With Motor

by 821295 in Craft > Cardboard

13 Views, 0 Favorites, 0 Comments

Boat With Motor

IMG_20250529_093137.jpg
Today we will be creating a functional motor boat with very few materials.


Supplies

IMG_20250529_094147.jpg
IMG_20250529_094250.jpg
IMG_20250529_093936.jpg
IMG_20250602_094815.jpg
IMG_20250529_093527.jpg
IMG_20250529_093814.jpg
The materials we need are a strong tape, two or more mouse pads 14 cm wide and
20 cm high, some small propeller or boat motor, batteries and a battery pad.

Cut Pad's

IMG_20250602_095520.jpg
You will fold the first mouse pad twice on the long side, the first fold will be at 3.5 cm, the half has to measure 6.5 to 7 cm




One Strip

IMG_20250602_100225.jpg
the other one you are going to cut it by one of its long parts and it has to measure 3.5 to 4 cm long

Two Strips

IMG_20250602_100406.jpg
and then you will do the same with the other part to have two equal parts

Triangle

IMG_20250602_100730.jpg
You are going to cut a triangle with a rounded edge, 3.5 cm high and 6.5 cm long.

Back

IMG_20250602_101210.jpg
You will stick one of the strips on one of the ends to close the back of the boat.

Front

IMG_20250602_101558.jpg
You will glue the other strip to the other end but not to close it. In fact, it has to end like the tip of an arrow and this tip has to have the measurements of the triangle that we cut.




Arrow

IMG_20250602_101737.jpg
You are going to put the triangle at the bottom of the arrow and stick it with tape.


Tape All

IMG_20250602_102317.jpg
You have to put tape on all corners and all parts where water can get in.

Final

IMG_20250602_102519.jpg
You're going to make a hole in the back of the boat, put the motor in the middle and glue it to the bottom of the boat as well as the battery pad.