Boat Shelf

This is a remix instructable. It is based on my instructable A boat from a single 2x4

If you saw my boat, then you know it was covered with a ugly plastic bag.

As a boat it was not really good but I like the construction therefore I decided to make a shelf for my towels.

please watch the video or have a look to my instructable

The cover was fixed with Duck-tape and it was not difficult to remove it. But it was a lot of work to clean all the glue rests with alcohol. I also removed the seat just with a hammer.

The feet are only three wooden blocks I screwed on.

I placed a piece of wood above one section and made a line with a pencil. Then I cut it with a jigsaw

Then I realized I cut it on the wrong side of the line. Therefore I added a little piece of wood to close the gap

The middle bar has a dado on one side. First I made this dado then I put the bar into the place. At this moment it was longer then necessary and it was easy to made a line on the front bar. Then I cut it, put it in place with wood glue and drilled a hole for a wooden dowel.

This was the same procedure for every other piece. Put it in place under the existing construction, make a line,

cut it and glue it in place.

I sanded it and added some layer of linseed oil.

It is not very strong but it is enough for towels.

If you like it, I am glad if you vote for it in the Shelving Contest 2016!

If you want to see more of my work, subscribe to my Youtube-channel