Board Art

by alinke in Circuits > Art

845 Views, 3 Favorites, 0 Comments

Board Art

thumb.jpg

Materials

12x20 Plywood 1/8" Thick

3M dual lock velcro tape

Boards

Laser Cutter (Optional)

Like many Makers, I've amassed several boards over the years, most of them collecting dust in my shop. So decided to make an art piece out of them.

velcro.jpg
IMG_0706.jpg
IMG_0708.jpg
IMG 0663
board3.jpg
board4.jpg
board5.jpg
board2.jpg
hanging_full.jpg
board1.jpg
holding_up.jpg

If you've got access to a laser cutter, you can customize the attached template "board art.svg" for your boards. The template is setup for a 12x20" sized piece of material. I used a Glowforge laser cutter on 1/8" thick plywood. I also used the 3m dual lock tape to secure the boards to the plywood in the event I need to use one of the boards.

Downloads