Bike Flashlight Mount With Angle Adjustment

clamps to handlebar. can hold most flashlights . can quickly reposition with one hand the angle of light while riding . has 15cm rise above handlebar to get light closer to eye level for less shadowing effect

light weight softwood

strong hardwood for bottom clamping piece

m8 wingnuts ordered from online , has 7 threads that wont strip compared to 3 threads from generic ones

m8 bolts 90mm

m4 or m5 bolts for clamping to flashlight

1mm stainless sheet

silicone rubber sheet 1mm for grip

a 2 x 21700 flashlight

cut hole in softwood with 30 or 32mm hole-saw

use a mitre saw to cut through the hole you just drilled , cut off 1/3

file down this part so it can fit on your handlebar

use 7 or 7.5mm drill bit to install bolts into softwood , lubricate holes with beeswax finish

cut heads off bolts after installing

file down bolts so wingnuts can screw on

install a hose clamp or similar on your handlebar to stop unit from sliding sideways

when finished tighten down the wingnuts hard , grip it from the top and push or pull to adjust angle