Best Blowdarts Ever!
Gather These Tools and Materials
Steel dressmakers pins
Shoe lace
Needle nose pliers
Superglue
Shoe lace
Needle nose pliers
Superglue
Fraying
Fray the end of the shoe lace, about 1cm, using a pin. Cut it off 1/2cm below where the fraying ends.
Pins and Glue
Place a pin through the frayed end and out through the unfrayed end so the pin protrudes about 2cm.
Clamp the unfrayed end with the pliers then soak with glue.
Clamp the unfrayed end with the pliers then soak with glue.
Snipping
Take the pliers or a pair of side cutters and snip off the sides of the glued end of the dart so that it is shaped like a triangle not a square.
Finished
See my article on Nerf Jolt Airsoft Firing for how to use in nerf guns
DISCLAIMER:
I AM NOT RESPONSIBLE FOR ANY INJURY, PARYLYSIS OR DEATH CONCERNED WITH THIS PROJECT. THIS PRODUCT IS NOT A TOY. YOU ARE FULLY RESPONSIBLE FOR ANY OF THE ABOVE LISTED UNDESIRABLES. FOR SAFETY REASONS, DO NOT POINT THIS AT ANYONE.
DISCLAIMER:
I AM NOT RESPONSIBLE FOR ANY INJURY, PARYLYSIS OR DEATH CONCERNED WITH THIS PROJECT. THIS PRODUCT IS NOT A TOY. YOU ARE FULLY RESPONSIBLE FOR ANY OF THE ABOVE LISTED UNDESIRABLES. FOR SAFETY REASONS, DO NOT POINT THIS AT ANYONE.