Bee Hive

Proto-Green 2022 proyect. Winnie the Pooh group.

🐝July-August🐝

Wooden pallet.

Carafe. (We use an 5l carafe)

🐝Be careful with the screws and the splinters!

🐝Do this with every plank to make sure that you can't find any splinter.

🐝Make sure that there are 20 cm on each side to make a have the hive some centimetres above the ground.

🐝To make the legs of the table, which will have the bee hive!

🐝We painted it yellow because of our name of the group "Winnie the Pooh". Also we used blue to combine.

🐝First we measure the bottle! We have to cut enough to make the structure.

🐝We cutted it first with a cutter to make a hole. After we use the slicer to cut it all.

🐝We did it with a cutter, because using a sander it was too complicated. Moreover, with the cutter you can rectify any error you had.

🐝We first did the model. We did it with EZCAD.

We did the top of the box, and the parts of the honey bee box.

🐝 We put our design on the machine and we left it cut the pieces.

🐝If it don't fit,cut more the bottle with a cutter.

🐝We put together some of the parts that were made in the cutter lasser, conneting the different parts as it was a puzzle.

🐝 We made holes in the wood to put some wire to make the "honey bee box" strucure,so bees can build and make honey there.

🐝We make the holes with a drill, so bees can come inside to make the honey. The holes we need to do in both sides.

🐝We screw the structure to make a kind of table to put into the bottle for the bees.

🐝This is how the proyect would looks like when it is finished!