Arrowhead Necklace
Hey there! Today I'm going to show you have to make some really rad Arrowhead necklaces!
Supplies
1.) Pliers
2.) Jewelry ends
3.) Jewelry Rings
4.) Pliers
5.) Scissors
6.) Leather cording
7.) And of course an Arrowhead!
Note: You don't have to use authentic arrowheads. You can use fake ones like me!
Wiring the Arrowhead
This part isn't too hard once you get the hang of it! Cut about two feet of wire and begin working from the top down. Leave about five inches hanging off the edge and wrapping it around about three times. Then take it and pull it down to about the end and pull it tight. Then bring it around the back and back up to the top, creating an X. Continue this once more to add strength.
Meet it back up at the top and twist it to the end with the other wire, bring it down to the base of the wire-twist. Loop it and hold them together with the pliers, twisting it together to form a loop. Cut off the excess.
Meet it back up at the top and twist it to the end with the other wire, bring it down to the base of the wire-twist. Loop it and hold them together with the pliers, twisting it together to form a loop. Cut off the excess.
Stringing the Arrowhead
Get your Jewelry Ends. ( Okay, that's what I call them but it's probably not the proper name. Of you know what they are called pls lemme know in the comments. Pic of them above)
You will need two jewelry ends. Cut a foot and a half of leather cording. Fold one jewelry end on. Slip the Arrowhead on the other side. Fold the second jewelry end on the other end of the leather!
You will need two jewelry ends. Cut a foot and a half of leather cording. Fold one jewelry end on. Slip the Arrowhead on the other side. Fold the second jewelry end on the other end of the leather!
Jewelry Clasps
Next, add the jewelry clasps. You may need to add a ring on each end depending on what kind you have.
(Sorry there is no pics for this step)
Wear It!
You're all done! Now go out and show of your beautiful necklace!