Arduino Nano Capacitance Meter

This project is practically three components because it's formed of a 16X2 LCD Display, a potentiometer 10K, and an Arduino Nano while the rest of parts are a PCB designed by me using EasyEda software, 1 X 40 HEADER, 0.1" SPACING, and 1x6 FEMALE HEADER. This tester can measure from 0.000 to 1mF.

Bill of Materials

What you will need:

1-Arduino Nano

1-16 X 2 LCD Display

1-PCB designed by me using EasyEda software

1-10 K Potentiometer

1-1 X 40 HEADER, 0.1" SPACING

1-1 X 6 FEMALE HEADER

Soldering Iron

Soldering 60/40 roll

Schematic

This is your schematic so that you can construct the project correctly. The diagram contains detailed information to complete it without any problem.

Preparing Your LCD

Taking the 1 X 40 HEADER, 0.1" SPACING, cut 16 pins and insert that part in your LCD.

Preparing the Arduino Nano

Taking the 1 X 40 HEADER, 0.1" SPACING, cut 1 x 4-pin and insert it from under the Arduino nano and solder on (5V, RST, GND, Vin). Now, cut 1 x 15-pin and insert it from under the Arduino nano and solder on (D12, D11, D10, D9, D8, D7, D6, D5, D4, D3, D2, GND, RST, RXD, TXD). Finally, insert the 1 x 6 FEMALE HEADER diractly on the Arduino nano between A0 and A5 and solder it under the Arduino.