Arduino IR Remote Control Robot Car - OSOYOO 2WD Robot Car Starter Kit

We will use OSOYOO 2WD Robot Car Starter Kit to make a simple remote controlled car. Once the car installation is completed, we will use an Infrared Remote to control the car movements including go forward, go backward, stop, turn left and turn right.

1x UNO R3 Board with USB cable 

1x OSOYOO Model X Motor Driver Module

1x OSOYOO UART Wi-Fi Shield

2x Tracking Sensor Module

1x Bluetooth Module 

1x IR Receiver

1x IR Remote Controller

1x Car Chassis 

2x Gear Motor with Wires

2x Wheel

1x Universal Wheel

1x Box for 18650 3.7V Battery

2x 18650 Battery

1x Battery Charger for 18650 Battery

2x Metal Motor Holder

1x DC Power Connector With Wires

1x Phillips Screwdriver

1x Hex Screwdriver

1x 2pin PnP Cable 20cm

1x 6pin Male to Female Cable

1x 20pin 15cm Male to Female Cable

1x Screw Package

https://osoyoo.store/products/osoyoo-2wd-robot-car-starter-kit

Refer to OSOYOO 2WD Robot Car Starter Kit Lesson 1 The Basic Installation of the Robot Car to assemble the robot car

Upload the code to Arduino IDE:

lesson-2.zip, 

IRremote library

Disconnect OSOYOO UNO R3 board from PC, put 2 fully-charged 18650 battery into battery box (check the box instruction and make sure polar direction is correct). Open the power switch in the battery box.

Press IR controller keys to control the car movements:

▲: Forward

▼: Backward

◄: Turn left

►: Turn right