Apple Charger Magsafe Connector Fix

Unplug you charger from the computer and the wall.

The outer housing is the white shell on your connector as shown on the the right in the image. Use a very sharp knife and very carefully repeatedly score the sides of the outer housing until you cut through it on all sides.

There may be some glue behind the outer housing so some prying is necessary to remove it.

The inner cover is made from softer white plastic (shown in the middle of the image). Cut on all sides to remove.

inspect wires to determine which ones are broken

remove metal collar and cut back about an inch of wire insulation

the wire that runs down the center of the cable connects at one location. The bare wires around it connected two locations. if the bare wires are broken twist them into two pigtails that are long enough for reconnection.

Tin the end of the wires and the locations that they will reconnect to.
then solder the connections making sure that the wires are routed so they group nicely at the cable.

put the inner cover on and then the outer housing

use plenty electrical tape to keep housing together and strengthen connector to transition. build up tape thickness around end of housing and create a taper so that any bending of the cable happens away from soldered connection.