Amongus Self Watering Planter Made With Tinkercad

SO today I am going to show you how to make among us self watering planter which is made using tinkercad you can also create this if you read the whole instructable. If you don't know how a self watering planter works I will tell you

There is an overflow hole, so excess water simply drains away. The soil soaks up the water from the bottom through a thread, so as long as you keep the reservoir filled, your plants get a consistent level of moisture, delivered directly to their roots. The reservoir system makes self-watering containers very water-efficient.

Among us body shape is cylindrical they have small round legs and a thick face glass. To make among us body follow the steps

1) For a round cylindrical body we will use a cylinder two sphere, set there side to 24 and then align then as shown in the picture

2) Now copy the body and make it small so that they can be used as legs, now place then as shown in the picture

3) For glass copy the body rotate it at 90 degree and place it on the head as shown in the picture

As the planter will be self watering we will need a storage for water at bottom. To make this follow the steps below

1) At first make copy of the whole body and then cut one from above till a fixed point and one from below to the fixed point

NOTE :- In my case I have use 17 as the fixed point

2) Now take a sphere and make a hole in the bottom part of the body, Now take two cylinder and make holes also in their legs for more water to store, Note that the holes should not make holes that let the water move out of the body

As this is a planter we have to make a place to pot a plant and we have to also make bones of the character so we have to also make holes below the upper part

1) Using a cylinder make hole for plantation and make a mini hole for the thread to pass

2) Now make two holes below the head as shown in the picture for bone

In among us game when a impostor kill a cremate, the body of cremate cuts in half's and a bone raise from lower part of the body. So we will also make the same, when we will open the planter a bone will raise from lower part. To make the bone follow the steps

1) Take a cylinder and two sphere, place the sphere in the upper part as shown in picture

2) Also make a rectangle box slightly smaller from that we used to make hole in the upper part

3) Now place them on lower part as shown in the picture

Now place the upper part and the lower part and you are done.

To pot plant first take a thread and pass it from the small hole that we make in the head, add soil and pot the plant