A Shelf With 1 Screw

A simple shelf for a workshop

You need a long board for the back and short boards for the shelf

Mark the position for the short boards where ever you want

The height of the saw blade is 1/4 of the width of the long board

and make your second cut.

The width of the spacer = the thickness of your short boards minus the thickness of your table saw blade

make so many cuts you need

The height of the blade should be the thickness of the long board

You can calculate, where this cut is to make but it is not important. Somewhere near the centre is good.

Use a 2nd spacer

The width of this spacer = the width between two opposite cuts of the long board minus the thickness of your table saw blade

Repeat this steps for any shelf.

use a mallet if necessary

or 2, if you want.

and fill it with stuff.

for all steps