A Flower Rack Made of Tiles and Wood

Mission: Waste materials recycling, saving and environmentally friendly!

Note: This is the work of a decade ago, there were only finished photograph, the following production process photo camera works is open again. So the tiles have been drilling.

Once, a group of furniture custom installation, after completion, the remaining number of bits and pieces.

There are a few short board stripe, and got two remaining tiles.

The use of cross-section of the end of the strip, drew lines on the tile. And positioning the screw hole.

To tile drill, impact drill with diameter 4 mm, first with the nail gently tap the location, and then use the appropriate items (such as brick) liner steady, careful force. Then using the holes on the tile, to make a mark on the end portion of the strip cross-section, for fixing screws accurately.

Mark the guide hole for the screw with the smaller diameter (about 50%) of the drill in the cross section of the slat end according to the hole mark defined above.

Install the three slats and two tiles with old screws that are collected daily. Note that the screw head is different, that is ,with the tile surface is a plane and cone surface two, as shown in the figure up and down type.

The installation is complete, as follows, and paste cushion at a bottom surface of the tile-equilibrating position contacting the ground.

Successful！