A CELL PHONE HAND SUPPORT

by OpenL4BNorte _ Hackerspace in Circuits > Tools

6815 Views, 127 Favorites, 0 Comments

A CELL PHONE HAND SUPPORT

WP_002192.jpg
material.jpg
List of Materials:
·      2 Packages of Sugru of the same color and 1 Packages of a different shade.
·      Scissors or cutter
·      A small plastic bag
·      1 stainless steel wire (approximately 25 to 30 centimeters long)

create by: Lizardo Augusto

996876_10152307934791515_961868208_n.jpg
Take the 2 packages of Sugru of the same color, open them with the scissor or cutter.

993357_10152307951641515_2122421965_n.jpg
1000412_10152307936156515_1648301591_n.jpg
IMG_3961.JPG
IMG_3962.JPG
IMG_3963.JPG
1069258_10152307938651515_1732025638_n.jpg
999368_10152307941611515_1342350457_n.jpg
Sugru comes in different colors and the consistency of the product is similar or just like clay, doesn’t stain and is not grease, having said that I proceed to prove the malleability by sculpting a little hand, but you can do your favorite figure.

IMG_3971.JPG
IMG_3972 - Copy.JPG
IMG_3972.JPG
IMG_3974 - Copy.JPG
15961_10152307953496515_1241421801_n.jpg
With the other package of Sugru and the small plastic bag, I made a base for the cell phone (as shown in the picture).

Assemby and Finish

IMG_3982.JPG
270215_10152307963426515_1385959330_n.jpg
IMG_3983.JPG
WP_002193.jpg
WP_002194.jpg
Attached to one point of the stainless steel wire the base and to the other end the little hand (as shown in the picture).

Let dry for 24 hours and the piece will be firm and very resistant.