7 SEGMENT DISPLAY

This instructable shows how to display 0-9 digits on 7 Segment Display using Arduino.

and these type of instructables are only for the arduino beginner.if you find any difficulties in following my tutorial please do leave a comment below so that i could post few good instructables for helping you in tecahing arduino.

let's start billing electronnics

• Arduino Uno 3
• 7 Seven Segment Display
• 2 x 220 Ohm Resistors
• Jumper Wires
• bread board

Connect the pins described below:

• Arduino Pin 2 to Pin 9.
• Arduino Pin 3 to Pin 10.
• Arduino Pin 4 to Pin 4.
• Arduino Pin 5 to Pin 2.
• . Arduino Pin 6 to Pin 1.
• Arduino Pin 8 to Pin 7.
• Arduino Pin 9 to Pin 6.
• GND to Pin 3 and Pin 8 each connected with 220 ohm resistors.

int a = 2;

//For displaying segment "a"

int b = 3; //For displaying segment "b"

int c = 4; //For displaying segment "c"

int d = 5; //For displaying segment "d"

int e = 6; //For displaying segment "e"

int f = 8; //For displaying segment "f"

int g = 9; //For displaying segment "g"

void setup() {

pinMode(a, OUTPUT);

//A pinMode(b, OUTPUT);

//B pinMode(c, OUTPUT);

//C pinMode(d, OUTPUT);

//D pinMode(e, OUTPUT);

//E pinMode(f, OUTPUT);

//F pinMode(g, OUTPUT);

//G

}

void displayDigit(int digit) {

//Conditions for displaying segment a if(digit!=1 && digit != 4)

digitalWrite(a,HIGH);

//Conditions for displaying segment b if(digit != 5 && digit != 6)

digitalWrite(b,HIGH);

//Conditions for displaying segment c if(digit !=2)

digitalWrite(c,HIGH);

//Conditions for displaying segment d if(digit != 1 && digit !=4 && digit !=7)

digitalWrite(d,HIGH); //Conditions for displaying segment e if(digit == 2 || digit ==6 || digit == 8 || digit==0) digitalWrite(e,HIGH); //Conditions for displaying segment f if(digit != 1 && digit !=2 && digit!=3 && digit !=7) digitalWrite(f,HIGH); if (digit!=0 && digit!=1 && digit !=7) digitalWrite(g,HIGH); } void turnOff() { digitalWrite(a,LOW); digitalWrite(b,LOW); digitalWrite(c,LOW); digitalWrite(d,LOW); digitalWrite(e,LOW); digitalWrite(f,LOW); digitalWrite(g,LOW); }

void loop() {

for(int i=0;i<10;i++) {

displayDigit(i); delay(1000); turnOff(); }

}