4 Person Pong
![Screenshot_20230124_103146.png](/proxy/?url=https://content.instructables.com/FRQ/7RO4/LDA9072G/FRQ7RO4LDA9072G.png&filename=Screenshot_20230124_103146.png)
I made a 4 person pong game because It allows me to play pong with multiple people at once. I also am a freshman at Kirkland ranch academy of innovation.
Supplies
![Screenshot_20230124_103712.png](/proxy/?url=https://content.instructables.com/FGV/EQH0/LDA9078K/FGVEQH0LDA9078K.png&filename=Screenshot_20230124_103712.png)
fusion 360 units: inch's
Creating the Platform
![Screenshot_20230124_103810.png](/proxy/?url=https://content.instructables.com/FED/F6ZL/LDA9078Y/FEDF6ZLLDA9078Y.png&filename=Screenshot_20230124_103810.png)
![Screenshot_20230125_102011.png](/proxy/?url=https://content.instructables.com/FRJ/NIL1/LDBOFU29/FRJNIL1LDBOFU29.png&filename=Screenshot_20230125_102011.png)
create a 24 by 24 platform. create another sketch on the side and from the bottom go up 1 inch create a 22 by .5 sketch and leave 1 inch on each side. and then on top create a 22 by .5 and leave a 1inch on each side. and do the same on the other side. then extrude the top center of the shape down 1.5 inches to cut.
Creating the Bumper
![Screenshot_20230125_102330.png](/proxy/?url=https://content.instructables.com/FN9/1EPR/LDBOFU3B/FN91EPRLDBOFU3B.png&filename=Screenshot_20230125_102330.png)
![Screenshot_20230125_102306.png](/proxy/?url=https://content.instructables.com/FU6/KTPI/LDBOFU32/FU6KTPILDBOFU32.png&filename=Screenshot_20230125_102306.png)
create a 2 inch circle and extrude it up 2 inches. now create a sketch in the side and make it a 1 by 1 square in the center. extrude it both direction to cut out a hole.
Creating the Ball
![Screenshot_20230125_102416.png](/proxy/?url=https://content.instructables.com/FG0/XI2O/LDBOFU58/FG0XI2OLDBOFU58.png&filename=Screenshot_20230125_102416.png)
![Screenshot_20230125_102504.png](/proxy/?url=https://content.instructables.com/FYZ/R11J/LDBOFU57/FYZR11JLDBOFU57.png&filename=Screenshot_20230125_102504.png)
you will create a circle and put a line through the middle and trim of the other end you should have a half cycle. the revolute the have circle and you have a ball
Putting It Together
![Screenshot_20230124_103126.png](/proxy/?url=https://content.instructables.com/FEJ/HPNS/LDBOFUI7/FEJHPNSLDBOFUI7.png&filename=Screenshot_20230124_103126.png)
create a new file and insert each design in the file(insert the bumper in 4 times). next you will need to ground the platform. then make a sliding joint on all the bars with the bumpers. and put the ball in the middle. and
done.