3rd Hand Magnetic Wristband

by wannabemadsci in Workshop > Tools

1585 Views, 26 Favorites, 0 Comments

3rd Hand Magnetic Wristband

IMG_9159.JPG
58a290c67a76df8712000906.jpeg

3rd Hand Magnetic Wristband

Ever need a 3rd Hand? Tired of reaching back down to grab another nail or screw or bolt?

Here is a quick solution - a magnetic wristband!

Provided with velcro fasteners and super strong neodymium magnets its that 3rd hand you've been looking for.

Materials

IMG_9047.JPG

You will need:

Duct Tape (I chose two-tone; gray and black, but that's up to you!)

1 set - Velcro Industrial Strength hook-and-loop self-adhesive fasteners 1-7/8 inch square

Several Neodymium magnets (I show disk and hard drive types - I used the hard drive ones - Easily recovered from a dead hard drive.)

Stapler (optional - in case the velcro adhesive wimps out)

Measure Your Wrist Circumference

58a291ce4557149bb3000341.jpeg

Take some scrap paper and wrap it around your wrist. Mark the overlap - this is the circumference of you wrist. The wristband needs to be approximately 3 inches longer than the distance around your wrist.

Cut Your Duct Tape to Length

58a29251471e3cb88c001cd5.jpeg

Cut your duct tape to be 3 inches longer than the distance around your wrist.

As mentioned earlier, I chose two-tone. With adhesive sides up I laid the grey on top of the black duct tape overlapping about 3/8 of an inch.

Trim the duct tape so that the outboard duct tape (black) is set back about a 1/4 inch from the end as shown.

Add Your Magnets

58a29309f9ff19d86f001ccd.jpeg
58a299cf45571420d400149c.jpeg
58a299a0471e3cb88c001cfd.jpeg
58a299727a76df871200092f.jpeg

Add the neodymium magnets to one end of the wrist band about a half-inch from the end.

Fold one side of the duct tape up and over the magnets and along the length of the wrist band.

Fold the remaining duct tape over the first. Trim the corners to 45 degree angles.

Fold the remaining tab over the wristband to complete the band.

Add Velcro

58a29a66f9ff19d86f001cf2.jpeg
58a29500471e3c9fa8000297.jpeg
58a294ad45571420d4001480.jpeg
58a2951a21ffe206f7001938.jpeg

Add the Velcro to the wristband.

The hook material goes over the magnet area on the inside surface (black side). It is set back from the end about a 1/4 inch.

The loop material goes on the two-tone side. It is set back from the end about 3/4 of an inch.

I had the stapler to use in case the velcro would not stay in position. But as it turned out the adhesive is very aggressive and does a great job staying put.

Get Out There and Put It to Work!

58a2962d8f9b88845100128d.jpeg
58a2969d45571420d4001486.jpeg
58a29655f9ff19d86f001cde.jpeg
58a296651441aaba1a001d0c.jpeg

Put on your wrist band and load it up with whatever your project needs and save yourself that extra step of reaching for that fastener that now is as close as your wrist!

Enjoy!