3D Printed Wine Bottle Carousel

This build is a complement to the Wine Glass Shelf build, you can see that here. This build is almost completely 3D printed with the exception of one hardware piece. With a simple finish and assembly, you can enjoy a rotating wine bottle carousel.

Materials:

3D Printed Carousel

3D Printed Base

Lazy Susan Turntable Bearing

Primer

Bronze Spray Paint

Clear Coat

Glue

Sanding Paper

Tools:

Orbital Sander (optional)

Any/all necessary protective equipment.

***Links provided are affiliate links if used to purchase something may provide Adylinn Studio a small commission.

The print time for the carousel is quite extensive at its current design so I would not feel comfortable recommending 3D Hubs since the cost would likely be too high to justify.

For those of you who do have a 3D printer, I recommend the following settings:

Carousel (decent surface quality to limit amount of sanding needed)

Filament choice not really important

0.2mm layer height

25-30% infill

Support required

Raft recommended due to minimal surface contact

Base

Filament choice not really important

0.2mm or higher layer height

15-20% infill

No Support

Brim optional

• Remove raft and support material.
• Sand carousel to the desired smoothness. Start with 220 or 320 grit and move up until you have a nice smooth part without visible print lines.
• Wipe the sanded parts with a lightly damp cloth or paper towel.
• Apply even and light coat of primer.
• Allow enough time for primer to dry, then sand lightly.
• Wipe the sanded parts with a lightly damp cloth or paper towel.
• Once the parts are dry, evenly apply light coat(s) of bronze spray paint.
• Once the parts are dry, evenly apply light coat(s) of clear coat.

I will sometimes use a healthy amount of spot putty to help with print lines on parts that are difficult to sand. I will typically do this after the final sanding and before the primer.

• Glue the turntable bearing onto the carousel and base respectively. Alternatively, you can fasten the bearing with screws.
• Insert wine bottles and enjoy your Wine Bottle Carousel!

Thanks for checking out the Wine Bottle Carousel 3D Printed build! If you enjoyed it, I post monthly builds using 3D printing on my website, https://www.adylinn.com/builds/.