3D Printed Phone Amplifier Spicker

Gadget to listen your music on your mobile with higher sound quality. Compatible with phones with measures between 5,5 to 7,8 cm wide and 1 cm thick.

Visit: Brico3D
Download: Files

Donate

For printing I recommend placing the amplifier upside down, with the sound output aperture resting on the bed and with the following parameters:

Resolution: low or medium (printing will take between 4 or 5 hours). Infill: 10%, Grille. Lower upper thickness: 0.6 - 0.8 mm. Supports: 5%, lines at 0.2mm distance. Rafts: 6-8 mm. Ensure correct leveling of the bed and a good hold with hair lacquer.