3 Watt Energy Saver

Hello! friends

Welcome to my another 2k16 "3 watt energy saver" project. In this project i'm gonna show you how to make your own homemad energy saver by using dead energy saver. Don't waste your old or dead energy saver. It's very easy to build.

So, let's get started.

Materials you'll need

Energy saver (dead or old)

Cardboard

1 watt x 3 smd led

Elfy or UHU

Electrical tape

3 watt led driver

Wires

Take an energy saver and open it like that you don't need upper part of energy saver (recomended for other projects tell you later) we need only lower part of the energy saver.

Put the lower part of energy saver onto the cardboard and marking it with the pen and cut it down according the marking. As you can see that in a picture.

Take a piece of cardboard which one you cut it down according to previous step now put some elfy or UHU on a cardboard and place the smd led according to the picture.

Now connect the all 3 smd leds in a series like (+ - + -) and make a hole at the center of the cardboard then pass the +ve and -ve wires through the cardboard hole and then connect those wires with led driver (+ve goes to +ve and -ve goes to -ve). Also connect the AC wires (which one comes through the lower part of the energy saver) with the led driver at AC side according to the picture.

Now join the leds cardboard with the lower part of the energy saver by using UHU or hot glue according to the pictures. Finally your 3 watt energy saver is ready to use.

Your energy is ready to use. Attach it into the holder and enjoy a bright light of the homemade 3 watt energy saver.

Share it with your friends and wait for my new project.

I hope you guys like it.

`