120 PSI - Air Gun
This project was inspired by Luke S. Video on YouTube about how to make an air gun. This project will cost $20 or less and take very little time to construct. You will need:
1 Foot 1.5" PVC pipe
1.5" Cap
1.5" Coupling
1.5"x1/2" bushing
1/2" Tee
1/2" female adapter
1/2" elbow
1/2"x1/4" brass bushing
1/4" threaded tire valve
1/2" ball valve
2 Foot 1/2" PVC pipe
1 Foot 1.5" PVC pipe
1.5" Cap
1.5" Coupling
1.5"x1/2" bushing
1/2" Tee
1/2" female adapter
1/2" elbow
1/2"x1/4" brass bushing
1/4" threaded tire valve
1/2" ball valve
2 Foot 1/2" PVC pipe
Line Up!
Just simply lime up your pieces like the picture
Lineup 2
Where you see the red circles, is where you should insert pieces of you 1/2" PVC tube- (to connect the pieces) The 1/2" PVC tube you bought needs to be cut so you can put various lengths in between the pieces
Connect Pieces
Apply primer and PVC cement to the ends of each piece and simply connect
Barrel
you can add a barrel to the valve (shown in picture) although it is not necessary
Pump It Up!
Connect a bike pun to your tire valve and pump air into it READ IMPORTANT BELOW
NO MORE THAN 120 PSI OR IT COULD EXPLODE
NO MORE THAN 120 PSI OR IT COULD EXPLODE
EXTRA INFO
DONT FORGET TO PUMP NO MORE THAN 120 PSI
Use paintballs or small objects - BE SAFE AND SMART - Please don't be a derp while shooting this - I don't want ANY Injuries
Use paintballs or small objects - BE SAFE AND SMART - Please don't be a derp while shooting this - I don't want ANY Injuries