10$ Tv Antenna Hack !!

by aKaMaKaVeLy in Workshop > Home Theater

202535 Views, 67 Favorites, 0 Comments

10$ Tv Antenna Hack !!

Remote_Control_Rotating_TV_Antenna.jpg
Make a better than avarage tv antenna that costs over 70$ using only 10$ worth of household items that work even better than a normal antenna !

Step 1

Grabbed Frame 60.bmp
You will need an old desk lamp that costs less than 5$ new.

Step 2

Grabbed Frame 1.bmp
Now Inside the lamp you`l find a small light bulb socket , unscrew it , it only has one screw holding it !

Step 3

Grabbed Frame 2.bmp
You will find that the socket is connected by 2 electrical wires one + and one - cut them off but don`t pull out the cable inside the lamp neck !

Step 4

Grabbed Frame 3.bmp
Now concentrate on the back of the lamp, using a drill you can make a 2,5 square cm hole , but since i did not dispose of a drill i just broke a hole in the back of the lamp ! either way is good as long as the hole is 2,5 square cm.

Step 5

Grabbed Frame 4.bmp
Take 2 ordinary table spoon forks that usually costs around 50 cents each , now straighten them up so that they don`t have that small curve .

Step 6

Grabbed Frame 5.bmp
Now bend the fork tips bend the 2 outer tips at 90* and the 2 inner tips only at 75* .

Step 7

Grabbed Frame 6.bmp
Now hold the forks together , if you did everything right then it looks like a steel spider shape !

Step 8

Grabbed Frame 7.bmp
Take a simple shoe lace !

Step 9

Grabbed Frame 8.bmp
Wrap the shoe lace around the forks to hold them tight together !

Step 10

Grabbed Frame 9.bmp
Remember the wire that we left in the lamp ? well take it and connect it 2 the forks , one cable on each fork !

Step 11

Grabbed Frame 10.bmp
Now take the forks with the cable and insert it to the lamp where the socket was and place it tight in the hole.

Step 12

Grabbed Frame 11.bmp
Take an old pair of rabbit ear antenna from an old radio or stereo or buy it for aprox. 4$

Step 13

Grabbed Frame 12.bmp
My Lamp had a very small support leg similar to a jaw and i simply added the rabbit ear antenna for extra signal and better reception !

Step 14

Grabbed Frame 13.bmp
Take a short tv cable with a qd3013 adaptor at one end

Step 15

Grabbed Frame 14.bmp
Now connect the rabbit ear antenna wires with the fork wires to the tv cable make sure all your connections are clear and well made , you can add shrink tubing to make the insulation look better or just use rubber duck tape !

Your All Done !

Grabbed Frame 15.bmp
My Lamp Received 8 Clear Channels even a few that only work with big parabolas ! try it it's easy and simple and really cool to use !