Basically Free Phone Mount for a Car

I have been looking and looking for a while at phone holders, finally I decided I was going to make one instead of spending $15 - 30 bucks. This phone holder I made should cost you less than a dollar. It will work for basically any size touch screen phone!
--------------------------------------------------------------

Materials

Paperclip (2X)

Rubber band (2-4X)

Spray paint (optional)

To start you're going to lift the outter part of the paperclip like in picture 2. From there bend that outter part upwards like in picture 3 and 4. Now bend a hook on the top part of the paperclip like in picture 5. Remember you need two paperclips so do this same process again to another paperclip.

Now take a rubber band and wrap it around the small base of the paperclip that you didn't bend, I used 2 rubber bands on the base, one on the upper part of the base and one on the lower, you will need all the area of the base covered by a rubber band. It's up to you if you wanna use 1 rubber band on each paperclip, or 2 on each.

Slide the hook into the vent like picture 1. Then turn the hook inside the vent so it sticks forward like in picture 2. Do the same with your other paperclip and have it a few inches away from your other paperclip. Depending on your phone size make sure the paperclips are far apart or close together for your phone to fit on.

I painted my rubber bands and paperclips black with spray paint so it looks better. You do not have to do this step. Now you have a phone holder for any touch phone! As you see in the pictures you can have the phone on its side or standing up. And it's holding a Galaxy S5, and a iPhone 5, and an Ipod touch. Also as you see I have taking pictures in a few different cars, so it will most likely work in any car with a vent! Enjoy your basically free phone holder! By the way your phone won't fall off. I was hitting hard turns with it on, and it didn't move once!!