( E.A.P) Eliminator Assault Pistol

Get ready to meet your doom on the battle field, the brick wall in your path. You've met it's predecessors the TBAP and the TBOS. And you've seen the teaser. So now it's time to meet the ultimate Oodammo pistol,  the Eliminator Assault Pistol.
The most innovative part is the on-the-go loading. All you have to do to load, is slide the orange connector up till it locks in place and push the bullets in. No more fussing with a guide rod in the mag, not even with a mag pusher. One of it's advantages over other oodammo guns is the ability to load the mag when it's still half full. You can also load all 17shots at once which only takes me about 5 seconds. Another good thing about the gun is that the true trigger, blocks the ram as far back as possible. Only 2 centimeters from the back, leaving 12 1/2 centimeters for the ram to gain speed. 
 
It might not look best to some, but it functions great. The E.A.P has a range of about 50 feet, a 17 round mag, and the same good accuracy most Oodammo guns have.

Let's recap:
50 foot range
Same great accuracy
17 round quick-load mag
True trigger
Good handle

Sound like a good gun?? Well let's start building.
Let me know what you think it only takes a few seconds.
Also don't forget to
 SUBSCRIBE
Killer~SafeCracker

First off I would like to say that my camera is not the best. So the pictures might be a tad fuzzy.

Picture 1: Build this thing.
Picture 2: Build this. It shouldn't be that hard.
Picture 3: Just build it.
Picture 5: Now connect the two part together.
Picture 6: Add the back on and your done.

Now that was as easy as pie.

Picture 1: Go ahead and build this.
Picture 2: Add the rods where shown.
Picture 3: Make these parts.
Picture 4: Add them to the side panel.
Picture 5: Make this.
Picture 6: Add it to the handle.
Picture 7: Make these parts for the trigger.
Picture 8: Add them to the side panel. Sorry for the picture being so bright.
Picture 9: Make this.
Picture 10: Add it to the panel.

Picture 1: Add the other side panel.

Now you're 1/2 done.

Okay here we go.
Picture 1: Build two of these.
Picture 2: Build these.
Picture 3: Add the third side panel.
Picture 4: Add the fourth side panel.
Picture 5: Add the mag like so.

Picture 1: Add that strip on both sides.
Picture 2: Add the wheels to the handle.
Picture 3: Push in the white rods as shown.
Onto the next step. -->

Picture 1: Insert blue rod.
Picture 2: Build ram.
Picture 3: Place band like shown. But if you use more then one make sure all but one are over the blue rod.
Picture 4: Add rubber band to the trigger.
Picture 5: Add rubber band to the orange connector like shown.

e rodPicture 1: First off push the orange connector up until it locks in place.
Picture 2: Just push in 17 bullets.
Picture 3: Release the pusher.

That's one way to do it. Now I'll show you the faster way.

Picture 4: Make these things.
Picture 5: Add the Oodammo on the rod.
Picture 6: Pull up the pusher.
Picture 7: Snap the 17 bullets in and remove the rod